Sparx Systems Forum

Enterprise Architect => General Board => Topic started by: DavidL on April 22, 2009, 04:19:58 am

Title: Parametric Model Simulation
Post by: DavidL on April 22, 2009, 04:19:58 am

I have created a very simple parametric model and would like to simulate it.  I have been looking at the following pages:

http://www.sparxsystems.com/uml_tool_guide/extending_uml/simulating_a_sysml_model.html
http://www.sparxsystems.com/uml_tool_guide/extending_uml/sysml_parametric_models.html

I created the following model:

(http://farm4.static.flickr.com/3542/3463462636_e5cd0459c5.jpg?v=0)

I tried to run the sim and I do not get any input parameters listed.

(http://farm4.static.flickr.com/3530/3463462672_0b9bcd7b4c.jpg?v=0)

I have the following code setup for my Adder block:
out = a * b.

What am I missing?

Title: Re: Parametric Model Simulation
Post by: Eve on April 22, 2009, 08:29:02 am

I don't know what you're missing.

But have you seen the very thorough example in the example model?

Open the diagram at the following path.

Project Models | Systems Engineering Model | Requirements Model | Constraint Blocks | «constraintBlock» EchoDSP | EchoDSP.

Title: Re: Parametric Model Simulation
Post by: Francoise on May 22, 2009, 09:03:27 pm

You are lucky, you have progressed more than I did : I even could not access the command "SysML / Add element srcript" neither the command "SysML / Simultate" !!!

Good simulations, Françoise.

Title: Re: Parametric Model Simulation
Post by: Eve on May 25, 2009, 08:29:11 am

Françoise, you probably don't have the correct edition of EA.  You'll need the Systems Engineering or Ultimate editions of EA to access the simulation functionality.