Sparx Systems Forum

Enterprise Architect => General Board => Topic started by: ZoranPavlovic on December 20, 2012, 12:44:19 am

Title: Installation Instructions - need explanation
Post by: ZoranPavlovic on December 20, 2012, 12:44:19 am

Hi 2 all
I have version 9.3. This morning I have DL-ed version 10.0
Then, I visited instruction for Installations, and I saw this

" .... If you have installed the evaluation edition of Enterprise Architect, uninstall it through 'Add/Remove Programs' in the Control Panel.
After downloading easetupfull.exe, double-click on it and follow the prompts to install the registered version of Enterprise Architect. "

OK, it is if I use evaulation version, but since I already use registered version, what is then Installation procedure ?
I think you should put it on the web site too.
regards,
Pavlovic

Title: Re: Installation Instructions - need explanation
Post by: qwerty on December 20, 2012, 04:20:17 am

Just run the installer, it will take care. At least when upgrading from 8 to 9 or 9 to 10 it will remove the installed version and install the new one. The evaluation is (except for some minor code addition inside) the same as he full version.

q.

Title: Re: Installation Instructions - need explanation
Post by: ZoranPavlovic on December 20, 2012, 05:23:54 am

Many thanks for answer.

I installed it, and now looking on the new features :)

have a nice day.