Sparx Systems Forum

Enterprise Architect => Suggestions and Requests => Topic started by: folded_book on May 12, 2004, 01:32:50 pm

Title: Centre Diagram on Printing
Post by: folded_book on May 12, 2004, 01:32:50 pm

Not sure if this has already been requested, but it would be nice to be able to centre the diagram for printing.

Title: Re: Centre Diagram on Printing
Post by: Stephen on May 13, 2004, 02:32:08 am

Would you not centre the diagram in the resulting document after documentation generation.

Presumably not a big job if only one or two diagrams.
Or not a big job if many diagrams but you edit the output template file. (I haven't tried this mind, so my apologies if this is misleading  :P)

Title: Re: Centre Diagram on Printing
Post by: folded_book on May 13, 2004, 10:36:04 am

Cheers for your suggestion Stephen.  I have never tried to mess about with the template files but I will.  The reason I made the suggestion is because I was in a hurry to print out some diagrams for a meeting and didn't have time to centre them on the diagram. Just been lazy I suppose - or busy :)