Sparx Systems Forum

Enterprise Architect => Suggestions and Requests => Topic started by: Dave_Bullet on July 29, 2007, 03:19:30 pm

Title: RTF generation - Connector source / target element
Post by: Dave_Bullet on July 29, 2007, 03:19:30 pm

I need to be able to list all the connectors under my diagrams in my RTF documents and be able to include the source / target element names for each.

Currently - you can only include source / target element names for a connector, when you list the element at a package level (not within the diagram section)

Sparx - can you please extend the connector under the diagram section in the RTF generator to be able to include source / target element information (to be consistent with the connector setting already under the element section?).

Thanks,
David.

Title: Re: RTF generation - Connector source / target ele
Post by: «Midnight» on July 30, 2007, 02:01:24 am

That's a very good idea David. And also one of those things that escapes notice (at least mine) until you run into it.

There is the possibility of listing a connector several times - in cases where it is shown on several diagrams - but handling these situations should be no more onerous than those where an element appears several times.

I am also assuming that you mean explicitly those connectors that appear on a diagram. This would exclude any connectors that are not visible on the (entire) for any reason.

David