Sparx Systems Forum

Enterprise Architect => Suggestions and Requests => Topic started by: Mr. Sanders on October 17, 2007, 02:02:39 am

Title: Icon in tool group header
Post by: Mr. Sanders on October 17, 2007, 02:02:39 am

Hello,

a little icon/button in the tool groups header, which are visible in the tool box would be nice.

The icon indicates that the tool group is pinned or not pinned inside the toolbox.

If implemented as button, a toggle functionality could be implemented for that.

Additionaly some arrows for moving tool groups up and down inside the tool box would be very helpful.

Greetings
Michael

Title: Re: Icon in tool group header
Post by: «Midnight» on October 17, 2007, 04:00:57 am

Good ideas Michael.

These seem to have been overlooked when the new toolbox was developed.

Title: Re: Icon in tool group header
Post by: Mr. Sanders on October 17, 2007, 04:06:33 am

Hello Midnight Guru,

of course drag and drop instead or in addition to arrows for moving the groups would be nice to.

And configuring the colour and font and ...
No just kidding.

Drag and drop would be very nice.

Greetings
Michael

Title: Re: Icon in tool group header
Post by: «Midnight» on October 17, 2007, 04:56:34 am

But...

Have you made this suggestion directly to Sparx Michael?

This is a user forum, though Sparx does monitor and participate actively. If you want to make a feature request, use the Feature Request link below the Support link at the bottom of any forum page.

Please search my recent posts for a best practice we use to keep both Sparx and the forum community in the loop when making feature requests or bug reports.

David

Title: Re: Icon in tool group header
Post by: Mr. Sanders on October 17, 2007, 07:06:22 am

Hi David,

no I haven't yet, but I will.

I can't find a posting from you, which describes keeping forum coherant with request.

Greetings
Michael

Title: Re: Icon in tool group header
Post by: «Midnight» on October 17, 2007, 07:39:31 am

Michael,

Try http://www.sparxsystems.com/cgi-bin/yabb/YaBB.pl?board=suggestions;action=display;num=1190821387;start=4#4.

I would have repeated the advice here, but I wanted to be sure my earlier post would actually show up in a search.

David

Title: Re: Icon in tool group header
Post by: Mr. Sanders on October 17, 2007, 08:15:38 am

Hello David,

OK, I sent the featur request.

Greetings
Michael