Sparx Systems Forum

Enterprise Architect => Suggestions and Requests => Topic started by: Helmut Ortmann on June 27, 2012, 07:53:28 pm

Title: Project Integrity Check with output of GUID
Post by: Helmut Ortmann on June 27, 2012, 07:53:28 pm

Hi,

it would be a good idea to add a GUID to the log of Integrity problems. The name often isn't sufficient.

Regards,

Helmut

Title: Re: Project Integrity Check with output of GUID
Post by: qwerty on June 27, 2012, 08:49:14 pm

I'd vote for not printing any information at all when the check is run. This is all internal information and nobody except Sparx programmers does have any idea what it means. It is just confusing. Further the help should advise that an admin should run this check once a week.

q.

Title: Re: Project Integrity Check with output of GUID
Post by: Paolo F Cantoni on June 28, 2012, 06:37:53 pm

Quote

I'd vote for not printing any information at all when the check is run. This is all internal information and nobody except Sparx programmers does have any idea what it means. It is just confusing. Further the help should advise that an admin should run this check once a week.

q.

Agree - except to allow two modes

• Default: Show nothing other than "No Problems" or "Problems were fixed" as appropriate.
• Advanced: comprehensive information about what the problem found was and a means to identify the items involved Name & GUID

Paolo