Sparx Systems Forum

Enterprise Architect => Automation Interface, Add-Ins and Tools => Topic started by: wschalch on August 24, 2010, 04:23:29 am

Title: MDG's SysML Add-In
Post by: wschalch on August 24, 2010, 04:23:29 am

Before I was using ARTISAN Studio for SysML modeling, but since we use EA for software developments, I've decided to start using MDG's Add-In for SysML compliance. What I've noticed is that this Add-In is not SysML compliant. I have version 1.0. Is there any other version, which is SysML compliant?
Best regards,
Wagner

Title: Re: MDG's SysML Add-In
Post by: Ignacio G. T. on September 15, 2010, 10:13:30 pm

I'm using EA Systems Engineering Edition (which implements SysML 1.1 internally, no with add-ins) and it seems rather SysML compliant.

Title: Re: MDG's SysML Add-In
Post by: philchudley on September 17, 2010, 06:35:24 pm

EA's built in SysML 1.1 is more or less SysML compliant. I use it occasionally, but I have noticed that you cannot display a Parts compartment within a Block element for example (you can in the MDG SysML 1.0 version)

There are other similar compartments defined in the SysML which again are not supported by Sparx

Because a Requirement element is already in EA, SysML uses the same element and hence its appearance differs from that defined in SysML.

Apart from this minor niggles, I find the SysML 1.1 works just fine. (The simulation of then parametric diagrams is a little limited however)

Cheers

Phil