Sparx Systems Forum

Enterprise Architect => Automation Interface, Add-Ins and Tools => Topic started by: Paulus on December 13, 2012, 05:21:22 am

Title: Quicklinker not working?!
Post by: Paulus on December 13, 2012, 05:21:22 am

Hi all,

Some time ago the quicklinker definition in my MDG technology stopped working, but -only on my development & test configurations-. On other machines the QL works.

I am at a loss what could be the cause. I went as far as completely uninstalling EA and re-installing but without effect. Creating the MDG technology on another machine produced a working QL but again, not on -dev/test-.

Obviously i must have changed something on my dev/test machines but i can't figure outy what... has anybody come across similar problems before? I noticed that uninstalling EA does not seem to remove a number of registry settings. Could this be the cause of the problem?

reg,

Paulus

Title: Re: Quicklinker not working?!
Post by: wikitect on December 23, 2012, 05:44:32 am

It's unlikely.

The Quicklinker functionality depends on a) it finding your MDG (it is where you think it is, without conflicts from an older version ...?) and b) the Quicklink definition enclosed within <QuickLink data= > tag.

I'd open the MDG up at the location Sparx EA is looking at to make sure the Quicklink definition is what you think it is and where you think it is. Could be a config management problem...