Sparx Systems Forum

Enterprise Architect => General Board => Topic started by: dstoicof on August 11, 2021, 12:48:42 pm

Title: Invalid Target for Sequence Flow
Post by: dstoicof on August 11, 2021, 12:48:42 pm

Hello,

I'm on version 15.1.  While using BPMN 2 to create a workflow I get the error "Invalid Target for Sequence Flow" when I try to connect an outcome of a gateway to a message using the Sequence Flow connector.  It works fine for the other leg (EndEvent).   I can only connect the two using the Association connector.  Is there a guide that explains when to use Sequence Flow and when Association connectors?

Thank you!

Title: Re: Invalid Target for Sequence Flow
Post by: KP on August 12, 2021, 08:28:23 am

The specification is here: https://www.omg.org/bpmn/index.htm

There are probably tutorials scattered around the web.