Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - crispan

Pages: [1]
General Board / Re: UML recognised certification
« on: May 24, 2004, 06:30:54 am »
IBM's 486 "certification" is geared to the usage of UML in the context of OO software development.
[There is no single IBM "UML certificate". s. IBM's training
services' page for detailled information]

OMG's OCUP certifications indicate knowledge of the structure of UML 2.0. This knowledge will come handy
when using OMG's model driven architecture approach.

I have successfully taken the OCUP-Fundamental certification exam and now I am going for the
next level ("Intermediate").

General Board / Re: Cannot change page setup
« on: October 14, 2002, 05:20:09 am »
I still have this problem, too.

For details look at my post "Diagram printing problem" from 09/12/02 at 11:52:52.



General Board / Re: Drawing bug: Custom Line Nodes
« on: September 13, 2002, 07:40:47 am »
Thanks for the hint and the fixing information.


Crispan  :D

General Board / Drawing bug: Custom Line Nodes
« on: September 12, 2002, 12:03:44 pm »

I am using ED V3.11 Build 503.

When I use custom lines with additional nodes (which were created with "Toggle line point at cursor") in super state or super activity diagramms and then move the super state or super activity diagramm the additional nodes (and only them) stay on a fix position.

So their position is relative to the origin of the diagram but not as it should be relative to the origin of the super state diagram.

Any hints when this will be "fixed"? ;-)



General Board / Diagram printing problem
« on: September 12, 2002, 11:52:52 am »

I am using EA V3.11 Build 503 on Windows 2000 with a network printer.

When I print a diagram its parts at the page borders are cut off, e.g. the headings of swim lanes.
When I try to change the page set up in order to increase the non-printable border the changes are ignored. When I re-open the page setup dialog the values are resetted to 0.

Any hints?



Pages: [1]