Connector label visibility

[Rik van der Schalie]

Hi All,

I'm having an issue with connector label visibility, in that only Source and Target Bottom labels are shown, even though, in the label visibility dialogue, all labels are marked as visible. I haven't found a global setting for this, but in another post it was suggested that default label visibility might depend on the connector class it was based on (UML 2.1, vs. IDEF1X, etc.).
Does anyone have any experience with this?
T.I.A.

[Paolo F Cantoni]

Hi All,

I'm having an issue with connector label visibility, in that only Source and Target Bottom labels are shown, even though, in the label visibility dialogue, all labels are marked as visible. I haven't found a global setting for this, but in another post, it was suggested that default label visibility might depend on the connector class it was based on (UML 2.1, vs. IDEF1X, etc.).
Does anyone have any experience with this?
T.I.A.

If the connectors have a shapescript attached, that overrides your choices.  Try turning off shapescripts for the diagram and see what happens.

HTH,
Paolo