Messages

1

General Board / Re: Who owns connectors?

« on: October 15, 2004, 01:12:31 am »

Hi!

I assume that connectors (entries in t_connector) between elements in a controlled package are stored in the xml (XMI) file, but how about those that connect elements belonging to different controlled packages?
Are they "serialized" to both? What happens if they no longer match when reading in the two packages?

Please tell me if this is the right forum to discuss this issue.

Alejandro

2

General Board / Who owns connectors?

« on: October 14, 2004, 11:21:48 pm »

Hi!

As connectors don't show up in the project view, it is not obvious where they live.
I wonder  where the information about a connector between elements in two different controlled packages is stored.

Alejandro

3

General Board / Re: Display Tag Value on Diagram

« on: September 18, 2004, 04:10:43 pm »

You could attach a note (coupled to the tag)....

4

General Board / Re: How do I copy 5 columns from one table to anot

« on: August 27, 2004, 07:32:21 am »

Hi!

Have you tried to expand the souce table in the project view while a diagram with the target table is shown and then click and drag the columns (one at a time)?

A

5

General Board / Re: Reverse engineer a Component view

« on: July 20, 2004, 04:54:13 am »

Thank you for the suggestion!
It was very intresting to look into the automation interface. The code producing a good starting point for my needs kan be found at http://amancay.net/code/DirCv.zip

Alejandro

6

General Board / Reverse engineer a Component view

« on: July 16, 2004, 01:59:03 am »

Hi!

Is it possible to "read" in a directory structure as you do with source code and just creating Components for each file (any kind!).
It would be wonderfull for documentation purposes.

Yours

A