Messages

1

Suggestions and Requests / Dockable or at least sizeable "bahavior"

« on: December 15, 2005, 03:50:50 am »

Hello!
Some time ago you introduced "initial code" edit box in class opration details. This was done at the cost of reducing the "behavior" edit box. Since I bet that writing initial code by designers is much less common than describing operation behavior, I regret that the "behavior" box is so small. Enlarging the window enlarges only the "initial code" box. I therefore suggest that the proportion between two boxes should be changable.
The ideal solution would make the "behavior" box dockable (the same as "Notes" box).

2

General Board / Re: How to connect a method/operation with its dia

« on: September 10, 2004, 03:51:56 am »

I am not sure if this answers your question:

A Method/Operation on a class is used when specifying messages between instances in a sequence diagram.  Make sure when you create a new object instance on a diagram that you drag in an instance from a class specifier from a logical view.  If you do, then the method names from the class specifier will appear when you select the dropdown on the Message Property window.  

There is some misunderstanding here. Sorry.
I'm not asking how to model the fact that I want a method to be called.
What I want to model is the implementation of a method. Ideally I would want to be able to add a sequence/activity diagram to a method (a diagram below a method in the project tree) but I know it's not possible in EA.
Any other solution?

3

General Board / How to connect a method/operation with its diagram

« on: September 09, 2004, 06:49:21 am »

How to connect a method/operation with a behavioral diagram? Where can I model the implementation of the method/operation?

Best regards

Adam