Messages

1

Automation Interface, Add-Ins and Tools / Re: Parsing the Layout of Diagrams

« on: June 03, 2024, 11:54:01 pm »

yes this could work, currently I am getting it to match position but only for a one page diagram by exporting with diagram.SaveImagePage() and simple

translation, but I need to concatenate pages for the larger diagram, nothing impossible!

Otherwise, thank you for your advice and opinions.


Erwan

2

Automation Interface, Add-Ins and Tools / Re: Parsing the Layout of Diagrams

« on: June 03, 2024, 09:51:03 pm »

I tried it and it doesn't work, because the "PutDiagramImageToFile" method only prints the diagram, compared to diagram.cx and diagram.cy which are the

diagram values ​​of x and y based on landscape and portrait format even if the diagram takes up less space. 

I will look for other method

Erwan

3

Automation Interface, Add-Ins and Tools / Re: Parsing the Layout of Diagrams

« on: June 03, 2024, 07:24:02 pm »

Yes, it's look like a translation problem, all position seems to draw the diagram but all my problem is here. I don't know how to retrieve the translation.

I tried to find manually the translation on a diagram by comparing rectangle area of different element, but it's a failed, I suppose that element have margin ?! And this is not a solution I have to know all the translation for all diagram so I couldn't make it manually.

I was hoping that exist a value to retrieve it or a way to calculate it, but I didn't find it.

Erwan

4

Automation Interface, Add-Ins and Tools / Re: Parsing the Layout of Diagrams

« on: June 03, 2024, 06:36:03 pm »

Hi !!

It's been a while since you posted this message but I have the same problem, have you or anyone found a solution. On my side I try to match the position value with the image snippet with "PutDiagramImageToFile()" and the position does not match the generated images.

Best regards,

Erwan