Page width

[timk519]

I'm getting my feet wet with EA Corporate edition, and so far so good, it's been a great help.

My issue right now is that for some reason EA thinks there's more content on the page than their actually is when I go to print it. I'm doing an "analysis", and have swim-lines configured. The print preview shows the right side of the page about an inch away from the nearest model element, which causes the resulting output to take 2x the amount of paper it should.

I've hit every page size / orientation setting I can think of - and found one symptom being that something's auto-scaling the doc to 97% rather than enabling the "scale to page" setting to remain enabled.

Could someone point me to whatever setting'll allow me to get this sized properly?

[Thomas Mercer-Hursh]

Did you go through all the steps to switch from A4 to letter or are you using A4?

Did you try the scale to 1 page option?