Author Topic: Sequence Diagramm Object creation (Read 3410 times)

cschleif · « **on:** October 20, 2005, 09:22:09 am »

hello again,
i have a question.
i have an object which creates 2 other object, when I want to create a diagramm I'm getting this:

why is there the break in the red cirle?
and where can I turn it off?

regards
christian

SF_lt · « **Reply #1 on:** October 20, 2005, 11:53:41 am »

it's the same, when using fragments as alt, opt and so on...

maybe sparxians have solution :-)

thomaskilian · « **Reply #2 on:** October 20, 2005, 02:49:06 pm »

I only get that when I right-click "end source activation" at message 2->3

cschleif · « **Reply #3 on:** October 21, 2005, 12:27:01 am »

i've found it,
i get that when i right-click "extend source activation"

thx a lot

john · « **Reply #4 on:** November 10, 2005, 02:02:33 pm »

something else: how did you manage to post that picture of the seqnece diagram.

I want also to paste a problem picture and do not know how

thomaskilian · « **Reply #5 on:** November 11, 2005, 01:15:16 am »

Quote

something else: how did you manage to post that picture of the seqnece diagram.

I want also to paste a problem picture and do not know how

see my other reply

Sparx Systems Forum

News: